Upload the drawings, calibrate the scale and measure the job — lengths, areas, volumes, pipe runs, trenches and counts — with every quantity connected to a rate and an estimate.
Measure a pipe run once and Fieldlink can generate the trench build-up — excavation, bedding and backfill volumes from length × width × depth with pipe displacement — all editable before anything is committed.
DN300 RCRRJ 186.4m Trench 0.9m wide × 1.8m avg depth → Excavation 302.0m³ · Bedding 25.2m³ · Backfill 263.6m³
Each measurement can carry a unit rate from your Rate Library. The estimate totals update live as you measure — and when the drawing gets revised, you re-measure the change, not the whole job.
PDF drawings and common image formats (PNG, JPG, WEBP). Multi-page PDFs are supported with per-sheet calibration.
Draw a line over a known dimension on the sheet (or use the drawing scale) and Fieldlink converts every measurement to real-world metres, square metres and cubic metres.
Yes — dedicated pipe, trench, volume, topsoil and cut/fill tools with depth and width inputs, plus automatic bedding/backfill/spoil derived quantities.
Yes — the Fieldlink AI Plan Reader scans the sheet and suggests pipes, manholes and quantities with confidence levels. You review and approve before anything enters the takeoff.
Quantities flow into the Fieldlink estimate, the estimate becomes the quote, and winning the job creates the job budget — one connected chain with no re-typing.
Takeoff → estimate → quote → job → crew & plant → field → safety & QA → cost → invoice. 30-day free trial, no credit card.
Build your next takeoff